Quote:
Originally Posted by jdobbs
BD Rebuilder only support backups via X264. X264, by the way, is far and away the best H.264/AVS encoder you will find.
|
Thanks jdobbs for your help. In fact I was just using DB Rebuilder V0.31.06 Beta But cannot seem to get it to start to encode. I am sure it is operator error somwhere. I am running windows 7 32 bit. I did read the setup info you posted . In the setup you wrote, " 8. Recommended for Windows XP only: Download and install WMV11 from Microsoft, and set VC-1 decoding to "disabled" in FFDSHOW (allowing the WMV11 codec to be used). This seems to be the codec with the fewest problem on VC-1. For Vista or Windows 7 -- select "wmv9"
In the FFDshow video encoder configuration I set the Format VC-1 to wmv9. I hope that is correct. Thanks for the program. Here is the log:
-----------------------
[22:43:36] BD Rebuilder v0.31.06 (beta)
- Source: GRAN_TORINO
- Input BD size: 27.67 GB
- Approximate total content: [01:56:34.779]
- Target BD size: 4.27 GB
- Windows Version: 6.1 [7600]
- MOVIE-ONLY mode enabled
- Audio Settings: AC3=1 DTS=1 HD=0 Kbs=640
[22:43:36] PHASE ONE, Encoding
- [22:43:36] Extracting A/V streams [VID_00004]
- [23:01:57] Reencoding: VID_00004 (1 of 1)
- [23:01:57] Collecting video information
- Source Video: VC-1, 1920x1080
- Rate/Length: 23.976fps, 167,707 frames
- Bitrate: 4,028 Kbs
- [23:01:57] Reencoding: VID_00004, Pass 1 of 2
- Encode failed. Retrying.
- Encode failed. Retrying.
- Reached retry limit. Aborting.
- FFDSHOW Revision: (3133)
[23:01:59] - Failed video encode, aborted
Any help would be greatly appreciated.