Follow-up on Live/Audigy multichannel routing
As I mentioned on the plogue forum, in their default installation, the kX drivers for the Soundblaster Live/Audigy swap the front and rear signals sent to the analog output jacks on the cards. This was done because the AC97 codec chip used for the fronts--especially on the SB Lives--was of inferior quality to the chip used for the rears. In the kX Mixer, there's a switch that will reverse this if a user doesn't want the swap.
Consequently, someone may be unaware of this and wondering why there's no sound when installing the drivers with only front speakers hooked up. In such a case, try either plugging the speakers into the rear channel output or using the switch in the kX control panel.
Regards,
Steve
Last edited by ursamtl; 25th June 2004 at 13:48.
|