View Single Post
Old 24th May 2010, 10:03   #10019  |  Link
GZZ
Registered User
 
Join Date: Jan 2002
Posts: 581
I have only had problem using two instance of eac3to when encoding to DTS using surcode, sometimes (rare cases) it happens that both instance use surcode at the same time and one instance finish before the other. Then it (sometimes) kills both process leaving a unfinished dts file. Maybe its the same that happens for you ?

You could properly check this by making a batch file with the same commandline repeated like 5-10 times and then just make it run over and over again to see if it fails at any point. If this work, then try to make 2 batch and run it at the same time. Dont use the same destination folder in both batch job, it will sure fuck it up.

Last edited by GZZ; 24th May 2010 at 10:05.
GZZ is offline