Quote:
Originally Posted by jdobbs
Exactly. Which is why the instructions say it is preferred...
|
But won't I inevitably eventually need ffdshow for some other program (AviSynth, VirtualDub, SolviegMM Video Splitter, etc), even if I don't need it for BD-Rebuilder?
If I wish to only use LAV for BD-Rebuilder (as, based on what you wrote, LAV is apparently better), but still install ffmpeg just in case I need it for other programs, should I use the same same steps and settings you outlined in your BD-RB thread, or other settings?
Also, unless I am misunderstanding something, your instructions in said thread for installing both LAV and ffmpeg require only the following:
1. Install ffmpeg and Haali before LAV, rather than after.
2. Make sure MPEG2, VC-1, and wmv9 are enabled in the ffmpeg video settings.
3. Make sure "Uncompressed" is set to "All Supported" in the ffmpeg audio settings.
Am I missing anything? Do I need to change any other defaults in the ffmpeg installation (seen in the numerous screencaps I posted above)? And is it safe to check
all of the options seen in this one photo (including those left unchecked by default), in case I ever need the unchecked components/plugins:
