Quote:
In short, DTSdec gives him a shit of 5.1 with "clipping".
|
Hmm... need to brush up on my French :-)
Tranzcode uses the same samples as DTSDec only it also contains the LFE data as output, so if the dts source has clipped output from the "unusable" 5.1 wav, so would the mono wavs of Tranzcode output. The stereo output can have clipped output from some dts source files from DTSDec which is why I added the gain adjust using @__% for stereo output allowing you to raise/lower the gain by % factor, but this has nothing to do with the mono wav or 5.1 wav output, which should not be clipped unless the source files used to encode to DTS were to begin with. When I get around to it I will redo the stereo output to avoid the clipping.