View Single Post
Old 2nd March 2013, 21:37   #17868  |  Link
tony359
Registered User
 
Join Date: Feb 2013
Posts: 84
Hi all,

First of all, a massive thanks for developing yCMS, it's amazing!
I am trying to load a 3dlut file into MPC-HC but I have the dreadful message "this 3DLUT file does not matche the input format required by madVR".
I have tested a bit of everything as input but with no luck.

I know I can load the values directly in madVR, was just doing some tests.

I have a professional colour meter. Using the AVS test disk, I was checking the results and I found that the grayscale after calibration reads the following x and y: 0.313 0.322. Is that the proper white point? I thought that rec 709 was 0.3127 0.3290. I'm happy with x, but what about y?
My monitor is a good one and already calibrated-ish. The original white is 0.312 0.317, not light years off.

Gamut is massively improved, my Dell is a wide-gamut and yCMS takes it back to what it's supposed to be, simply amazing.

Thanks for your help.
Below my calibration file.
Tony

# Set input format
Input_Format yRGB RGB_Video 8

# Set output format
Output_Format yRGB RGB_Video 16

Grayscale_Measurements
0 1 0.125 0.3004 0.3283
10 1 0.919 0.3068 0.3225
20 1 3.28 0.3119 0.3174
30 1 9.10 0.3126 0.3173
40 1 17.9 0.3133 0.3172
50 1 31.2 0.3133 0.3163
60 1 47 0.3148 0.3189
70 1 67.5 0.3156 0.3186
80 1 93.3 0.3148 0.3195
90 1 120.3 0.3139 0.3214
100 1 150 0.3130 0.3218

Gamut_Measurements 1

43.9 0.6751 0.3203
93.5 0.1825 0.7023
12.1 0.1477 0.0622
150.0 0.3130 0.3218

Gamma_Curve 1.0 2.2
tony359 is offline   Reply With Quote