View Single Post
Old 22nd March 2016, 03:54   #37010  |  Link
70MM
X Cinema Projectionist NZ
 
Join Date: Feb 2006
Location: Auckland NZ
Posts: 310
Quote:
Originally Posted by Warner306 View Post
You can reset madVR to its default settings by finding the madVR plugin folder in JRiver and running the "reset settings" file.

To improve the performance of smooth motion, try increasing the size of the GPU queue size in general settings. This will provide greater protection against these glitches.

For your refresh rate problem, madshi mentioned you can use madVR profile rules to create profiles for devices -> display modes. You could set your entire pre-show content to be played at 60 Hz and the feature at 24 Hz.

Select devices.
Click create profile group.
Add display modes to the profile group.
Create two profiles: name one folder something like "Pre-show" and the other "Feature."

if (fileName = "introduction.mkv") "Pre-show"
else if (fileName = "trivia.mkv") "Pre-show"
else if (fileName = "trailers.mkv") "Pre-show"
else "Feature"

Leave the display modes field blank under "Pre-show." Under "Feature," enter "1080p23."

One profile will play without refresh rate matching. The other will switch to 1080p24 when the feature starts.
Hi Warner, ok this all sounds very interesting but when it switches from the 60 content to the feature at 24 Im back to the same old problem with the SLOW SYNC of the JVC RS600 projector, arnt I?

The proj takes up to 17+ secs to sync between 60 > 24, it plays the audio but clips all the video until it finally hand shakes. You miss all the logos and intro of the feature, its horrible!

This was the whole reason to remain on 60 for all the files, trailers, shorts we play before the feature at our film club.
The 24 feature was then to remain also on 60 so everything transitions nice and smoothly for files and feature, nothing clipped or missing on the screen....
70MM is offline   Reply With Quote