Doom9's Forum - View Single Post - smartLabs tsMuxeR: Transport Stream muxer

belcampo · 8th April 2009, 11:02

1st thanks for the excelent muxer, needed this tool badly for my PCH for playing over a nfs-share, ffmpeg created ts files often stuttered.
Now I was adding dvb-based teletext subtitles, demuxed with projectx, to srt format which play fine on the PCH, but NOT with mplayer under linux. I discovered that a file muxed from raw mpa mpv files, made by projectx, always starts with time code of about 600.
So the srt is 10min ahead of what is displayed. Playing the mpv with the srt is OK. The PCH doesn't seem to care. An older Windows-version of tsMuxeR began time-code with 4200 as far as I remember. Is there any reason for this, or am I doing something wrong?

8th April 2009, 11:02	#3167 \| Link
belcampo Registered User Join Date: Dec 2007 Posts: 8	1st thanks for the excelent muxer, needed this tool badly for my PCH for playing over a nfs-share, ffmpeg created ts files often stuttered. Now I was adding dvb-based teletext subtitles, demuxed with projectx, to srt format which play fine on the PCH, but NOT with mplayer under linux. I discovered that a file muxed from raw mpa mpv files, made by projectx, always starts with time code of about 600. So the srt is 10min ahead of what is displayed. Playing the mpv with the srt is OK. The PCH doesn't seem to care. An older Windows-version of tsMuxeR began time-code with 4200 as far as I remember. Is there any reason for this, or am I doing something wrong?