Quote:
Originally Posted by GZZ
I have only had problem using two instance of eac3to when encoding to DTS using surcode, sometimes (rare cases) it happens that both instance use surcode at the same time and one instance finish before the other. Then it (sometimes) kills both process leaving a unfinished dts file. Maybe its the same that happens for you ?
You could properly check this by making a batch file with the same commandline repeated like 5-10 times and then just make it run over and over again to see if it fails at any point. If this work, then try to make 2 batch and run it at the same time. Dont use the same destination folder in both batch job, it will sure fuck it up.  |
I'm not using surcode. But the same could be happening with the arcsoft decoder. I'll give it a try, thanks for the input.