PDA

View Full Version : "ERROR: File V010... shows completed, but no .M2V file exists. Aborted"

simps
27th June 2005, 17:54
@Jdobbs

I have the free 0.93beta DVD-RB, and CCE 2.5 SP
I always get this error with DVD-RB, when it will start the encode process...
Is there a solution for this problem??

Tkz,
Simps
Tore
27th June 2005, 18:39
Are you using ECLCCE with v2.50 of CCE?
simps
27th June 2005, 18:59
I have tryed both...
I got the same problem....

Tkz,
Simps
Tore
27th June 2005, 19:15
Try using rockas installer.
It could be that you have something wrong with your setup.
htc10825
28th June 2005, 14:27
This happens when the *.ecl file was modified (or created) incorrectly. Check:
1) the last line of your rebuilder.ecl must contain at least 2x (lf,cr) - i.e. 2 empty lines. If not, the RB will cut up the last line of item.ecl and cause the error message.
2) extract the problem session in rebuildr.ecl and compare it with item.ecl to see if there is any diff.
3) If problem still exist, extract a similar session in neighbourhood of the problem session in rebuildr.ecl and compare it with item.ecl to see if there is any diff. except filename etc.
htc10825
28th June 2005, 14:40
use the tool "ECLStart" to encode the missing segment(.ecl file = item.ecl)
tarzani
29th June 2005, 14:52
@Jdobbs

I have the free 0.93beta DVD-RB, and CCE 2.5 SP
I always get this error with DVD-RB, when it will start the encode process...
Is there a solution for this problem??

Tkz,
Simps

Do you have scratches on your source disc?
I got same problem, but there's a scratch on my source disc. Now i'm not sure if the scratch caused the error or not.
I'm using dvdrebuilder v0.82 freeware (beta) and CCE 2.70.02.00 trial.
http://forum.doom9.org/showthread.php?t=96195

BTW.
Have you solved this problem?
trebor_07
13th July 2005, 12:04
I get the same thing here using cce 2.70 and adjusting ecl like:

Just replace the:
; Cinema Craft Encoder SP -- Encoder Control List
; Created by DVD Rebuilder

with:
; CCE SP Trial Version -- Encoder Control List

at the top in REBUILDER.ECL

This method used to work perfectly when using an old 0.74 version of Rebuilder but now with the latest 0.93 i keep getting .m2v missing all the time :(
Tried both with installer and "normal" setup with same result
trebor_07
14th July 2005, 22:51
Doing the exact same way as above but using cce 2.67 works flawlessly so i'm ok for now :)
Werd though that dvdrb 0.74 and cce 2.70 works but dvdrb and 0.93 and cce 2.70 don't... ?