New CCE 2.50 install, .93.2 and no go

[markrb]

I have been using 2.70.2.1 for awhile and wanted to try 2.50.
I installed 2.50, ran it once to create the registry entries.
Added the path to 2.50 in RB.
Changed RB to use 2.50.
When I goto encode I get the following error.
From Log:

[09:06:44] Phase I, PREPARATION started.
- CCE SP v2.50 encoder selected.
- "Movie Only" mode is enabled.
- VTS_06: 3,071,456 sectors.
-- Scanning and writing .D2V file
-- Processed 139,270 frames.
-- Building .AVS and .ECL files
- Reduction Level for DVD-5: 84.0%
- Overall Bitrate : 5,888Kbs
- Space for Video : 4,175,274KB
- HIGH/LOW/TYPICAL Bitrates: 6,579/786/5,888 Kbs
[09:13:02] Phase I, PREPARATION completed in 7 minutes.
[09:26:37] Phase II ENCODING started
- Creating M2V for VTS_06 segment 0
-- Encoding resulted in no .M2V, retrying.
- Creating M2V for VTS_06 segment 0
-- Encoding resulted in no .M2V, retrying.
- Creating M2V for VTS_06 segment 0
[09:27:45] Phase II ENCODING started
- Creating M2V for VTS_06 segment 0
-- Encoding resulted in no .M2V, retrying.
- Creating M2V for VTS_06 segment 0
-- Encoding resulted in no .M2V, retrying.
- Creating M2V for VTS_06 segment 0

I tried looking at the stickies and a search, but so far came up blank.

Thanks,
Mark

[robot1]

you need EclCCE.
Run EclCCE and let it point to the CCE executable.
Then, in DVD-RB, point to the EclCCE executable.

[markrb]

EclCCE for 2.5?
I thought it was only for 2.66/2.67.

Ok now I see it in the Sticky. Missed that one.
I am coming from DVD2SVCD and with 2.5 it wasn't needed.

Thanks
Mark