trentscan
21st January 2005, 09:36
Hey there guys. I have had something strange start to happen and wondered if anyone else has had this happen to them. I've been working on a series of disks and the first 6 or so of them all converted just fine using the Big 3 instructions (new version). Now in the past few disks that i've tried all runs fine till after docce4u completes... at that point I open up scenaid and normaly i would select the correct dir and off it goes and normally the hard drive is active or the processor is very bussy and in 10 mins or less senarist would pop up and start running.. Now tho I select my dir in scenaid and the harddrive light comes on and I can see that it's doing things up to the point where it launchs automate scenarist. After that happens I have no disk activity. No processor activity and after maybe 30 mins or so all of a sudden scenarist will pop up and start to run. But the entire 30 mins the automate scenarist process is running in the background along with scenarist but it seems like it's not doing anything. Before when scenaid would launch automate scenarist there was lots of processor usage or disk usage for a few mins and then scenarist would come up and start to create vob files.. now I get the long delay with no activity and in time it does finish and create everything just fine, just not sure what's changed. Any suggestions?