RB 0.65 Runtime error "52" bad filename or number

[Msc_Alex]

Last night installed my new 0.65b. :)
So i gave it a go with a "hard" one ' Terminator 2 ' R1, in the preparation
--Video demultiplexing... I got this error.
Rb had demux about 10 cell's.
http://img45.exs.cx/img45/6276/t5.gif
http://img93.exs.cx/img93/7948/Clipboard.gif

[wmansir]

@jdobbs

I received this error when selecting a new source directory when the Output/Working directory did not exist (deleted after previous project). Enable Output directory was OFF.

It's probably not related to the original poster's problem, but since it's the same error message I though I would just add it here.

[jdobbs]

I'll have to check this out. I didn't do much testing with ReJig and multiple-angles as I did with CCE.

[colinhunt]

I got this error on RB 0.64a on a disc which does not have BOV or multiple angles. I'm now trying the same disc with 0.65 with logging enabled.

edit: same error popped up with 0.65. The log file says it was still doing the PREPARATION PHASE, VTS_01 was done and the last line in the log is

"Scanning and writing .D2V file"

for VTS_02 (the disc has only two VTS's).

D2VAVS directory contains 491 files, the last of which is an empty .FLG file. The disc contains a sketch show which has a chapter number for each sketch, i.e. the disc has a gazillion chapters. Hope this helps.

:colin

[colinhunt]

Tried the disc with Special Error Processing enabled - same error. Another attempt with Dynamic Allocation enabled ended in the same error as well.

[Msc_Alex]

Originally posted by colinhunt
The disc contains a sketch show which has a chapter number for each sketch, i.e. the disc has a gazillion chapters. Hope this helps.
:colin
That funny t2 breaks down at I think chapter 9 fun part is, all the previous chapters have 1 cell. Chapter 9,10,11 have 41,17,33 cells !!


:sly:

Edit :confirm that regjig causes this problem cce works ok in prepare.

[wmansir]

Originally posted by wmansir
@jdobbs

I received this error when selecting a new source directory when the Output/Working directory did not exist (deleted after previous project). Enable Output directory was OFF.

It's probably not related to the original poster's problem, but since it's the same error message I though I would just add it here.

Bump because I just received the same error in v0.66a for the same reason.