Quick Question about EclCCE

[Angelus]

The latest EclCCE says that you need to edit the .ini and add this to it: VafFix=1

I've done this and for Robshot-Bach in BatchCCEWS, I get 2, 1/1 passes and then it goes into the main enocding of the movie, 4 passes. I was just wondering if this is right, because some of my earlier backups only had one first pass before encoding. Sorry but I was just wondering about this. Thanks

[jel]

i believe that 'fix' was for an earlier version of BatchCCE. It is no longer needed.
...unless someone tells me other wise ;)

[Darklistener]

Hi
this fix is only needed if you use ecl version 1.8 or higher and docce4u or BatchCCEWS 0.9.1.4 or lower.

[Angelus]

found my answer after looking around for a little while:

Originally posted by JuanC
That's not normal: Do you mean the vaf creation? Is it creating the vaf file twice? If so, make sure you are using BatchCCEWS v0.9.1.5 beta & ECLCCE 1.81 and check your ECLCCE.INI file (usually in the woosoft\batchccews folder) for the parameters VafFix and create_new_vaf. They should be =0, or shouldn't exist. Hope that helps.

Originally posted by JuanC
You need the VafFix=1 setting for previous versions of BatchCCE. You don't need that with this last one (0.9.1.5 beta). Take a look at this post from BBWoof (http://forum.doom9.org/showthread.php?s=&postid=500415#post500415) in this very same thread.

http://forum.doom9.org/showthread.php?s=&threadid=75765&perpage=20&highlight=eclcce%20vaffix&pagenumber=3

I guess I should have looked a little more b4 posting, my bad :)