Error while rebuilding! How do i rebuild "encoded files" again?

[biggy7]

just used DVDRB 0.49, and its giving me great results, just backed up a film , did the encode bit fine at 5 passes. And when i clicked rebuild, it said error 0300 i think it was. and it exited the program.

so how do i rebuld these encoded files again, without going through the whole encoding process again? got a foler named : D2VAVS with aload of .vaf etc etc files

any ideas?

thanks!

[Noah]

Uhhhh....click "rebuild" again.

[biggy7]

ive had to re start DVDRB again cos the error said it would exit the program.

so i re opened DVDRB, source is the orginal vobs that i wanna encode, and working dir is the destination.

but i already have a folder named D2VAVS which has 5 pass encoded files in it.

i just need to rebuild that folder, but how do i do that?

[jdobbs]

Originally posted by biggy7
ive had to re start DVDRB again cos the error said it would exit the program.

so i re opened DVDRB, source is the orginal vobs that i wanna encode, and working dir is the destination.

but i already have a folder named D2VAVS which has 5 pass encoded files in it.

i just need to rebuild that folder, but how do i do that? Unclick "One Click Mode" and when the three buttons appear, push "REBUILD"

[biggy7]

thanks mate!

im still getting error 0003, and i did use dvd stripper to strip some of the extra's out of the film before i used DVDRB, so im guessing its cos of this :(

will try it again with full movie with nothing stripped.