Where am I going wrong in DVD-RB 0.50b

[atropos]

When I start 'REBUILD' I am always getting the following error message:

"There is nothing to do. DVD-RB couldn't locate the apprpriate files in working directory. You must PREPARE and ENCODE first. Aborting."

But I have already prepared and encoded the files. :confused:


atropos

[jdobbs]

Your working path must have changed. You get this error when DVD-RB attempts to find the .M2V files for the rebuild -- and the directory ...\D2VAVS doesn't exist or is not accessible. That directory is created in the PREPARE phase.

[Joergen]

Or, if you have an old version of ECLCCE it creates .MPV files instead of .M2V. You can rename the mpv to m2v (ren *.mpv *.m2v) to save your project, then update your eclcce.

[Hooterman]

I'm getting the same message.

It varies on what version of cce I'm using though.

When using cce 2.5 I get that error.

If I try to use cce 2.66 I dont get the error, but when Rebuilder opens up cce it basically hangs, and I have to kill it to get out. I let it run for 30+ hours just to make sure it just wasnt going slow, but nothing.

I'm using EclCCE 1.81 which I believe is the newest.

And my D2VAVS folder is in the working directory and seems to be all like it should be.

What else can I try?

[Hooterman]

anybody have any suggestions?


or atropos have you figured this out?


thanks,

[sweetness]

try using QuEnc see if you get the same problem. if not then your settings might be messed up(paths, right versions..)
also try using a older version of DVD-RB see if that helps