DoItFast4U 1.4.0 video stream detection

[NastyBob]

I just finished backing up The Italian Job and The League of Extraordinary Gentlemen using DoItFast4U 1.4.0 and BatchCCEWS 0.9.1.2. Everything worked fine, except on The League of Extraordinary Gentlemen main movie. DoItFast4U didn't enable IVTC (i.e. no IVTC operation on source and no pulldown on output). I din't notice it until I watched the movie and noticed the jaggies on TV. I verified the need for IVTC using the doom9 guide (3 good frames + 2 interlaced in every 5). I ended up using Telecide()+Decimate() and 2:3 pulldown and it came out looking fine.

The reason I am confused is that the main movie VOBs for both DVDs report the same in DVD2AVI (FILM 99% + progressive). DoItFast4U enabled ForceFilm and 2:3 pulldown for The Italian Job, but not for LoEG.

I'm kinda new to the big 3. Did I do something wrong, or do you need to verify the output from DoItFast4U before re-authoring the video streams?

[Eyes`Only]

in the log, what does it say when it analyzes the main movie?

[NastyBob]

Originally posted by Eyes`Only
in the log, what does it say when it analyzes the main movie?

Is this the section to look at ?

(20:47:54) Analyzing AVS
(20:47:57) 197999 frames, fps=29.970000, mins=110.109554
(20:47:57) Adding no-pull to the filename of this .avs
(20:47:58) Added 110.109554 minutes to Main Calculations (Total is now 110.109554)

[Eyes`Only]

no, there should be a part where it says somthing similar to:

(17:53:12) Analyzing .D2V file
(17:53:12) total lines=835
(17:53:12) d2v analysis= 0.0.12256.0
(17:53:12) ---->INTERLACED Film detected (extra).Decomb selected for VTS__11_P01.16~9

[NastyBob]

no Analyzing D2V. Is there a setting that I missed?

[Eyes`Only]

You need to have the Autodetect NTSC button selected. If not, it will skip detection and keep files in their native form.