CRC error

[Niño]

I always get I/O error when trying to rip with DVDDecrypter as soon as the program and tries to read my disk. Smartripper or Vstrip don't work too.
If I ignore all the error messages everything work fine.

That's my error message:
http://disagio2002.supereva.it/screenshot.JPG


Thanx

[LIGHTNING UK!]

You need to sort out your drivers. UDMA CRC errors arent good.
So its either the drivers, or you disable DMA on that drive.
By ignoring the errors, you're inserting a whole bunch of '0's where there should be data. That is also bad :)

[Niño]

As written here there are no drivers or firmware for my DVD-ROM: :(
http://www.teac.com/DSPD/support/dvd_drives/dv516e_drv_firmware.htm

Does something change if I'll put it as "master" instead of slave?

Thanks a lot.

[LIGHTNING UK!]

No, not for your drive, for your IDE controller / the motherboard.
Also, double check you are using a decent cable...this could also cause problems if faulty.

[Niño]

Last drivers still don't work, but my DVD-rom was new, so I changed it with a LiteOn, and now everything seems to work fine :)

Thanks a lot man.