Unable to Load m2v into Maestro

[swim2383]

ok i encoded the m2v (using avisynth and cce) and then used pulldown (cause i used forced film with the counte of monte cristo) then when i went to load it into maestro i get a frame rate error?

wth? any ideas...
is it because it took about 20 or 25 seconds when i was saving the d2v file for it to reach 95% film?

any info would be great thx!
cure

[TRILIGHT]

Are you sure you aren't mix matching PAL and NTSC settings? If you are in fact working with PAL, the pulldown process is not needed at all. If NTSC, you do need it but you may have Maestro set to PAL instead. Double-check all of your settings to be sure your framerate is correct.