burelom
20th November 2002, 14:09
Hello,
I'm trying to build a backup station for our small office using 6xPioneer A104. Unfortunately, I can't found an IDE controller which can handle my additional A104 drives properly. For example build-in HighPoint's RAID controller doesn't recognize them at all. Promise's UltraTX2 goes a little bit better- drives are recognized at a boot time but after that XP can't access them at all (disk not found bla bla bla)
So, at this moment my configuration looks like this:
4xA104 hang on on-borad IDE0 IDE1 channels and two mirrored HDD hang on on-board RAID controller (ABIT MAX motherboard)
How can I add the rest of my drives to PC ? Which IDE controller should I use ?
TIA,
Burelom
I'm trying to build a backup station for our small office using 6xPioneer A104. Unfortunately, I can't found an IDE controller which can handle my additional A104 drives properly. For example build-in HighPoint's RAID controller doesn't recognize them at all. Promise's UltraTX2 goes a little bit better- drives are recognized at a boot time but after that XP can't access them at all (disk not found bla bla bla)
So, at this moment my configuration looks like this:
4xA104 hang on on-borad IDE0 IDE1 channels and two mirrored HDD hang on on-board RAID controller (ABIT MAX motherboard)
How can I add the rest of my drives to PC ? Which IDE controller should I use ?
TIA,
Burelom