Scenarist and forced subtitles

[rjgn]

I've figured out how to edit the subtitle file produced by subrip in order to set a whole subtitle stream in Scenarist as forced.

However I'm looking for a way to selectively force only some of the subtitles in a stream.

I know it's possible in Maestro but I'm looking for a way to do it in Scenarist as I'm ripping a multi-pgc title and it's far easier to do it in Scenarist.

Is this possible and if so how? I know I could get rid of all the non-forced subtitles in the original stream and use a copy of this as a forced stream but it would be a pain going through and deleting them all. So is there an easier method?

[rjgn]

Ok I've figured it out :)

You open up the Simulation Window, find the subtitle you want to force, make sure Design Mode is selected. Then check that "Subpicture and Highlight" and then Data is selected in the bottom part of the window and scroll down. Then for each subtitle you want to force click "Forced Start".

Just in case anyone else needs to know as I couldn't find the info elsewhere on the forum.