DDR 333 RAM Modules Samsung and Nanya

[Frank_IX]

Hi Folks,

has somebody heard something about incompatibilities between Samsung and Nanya DDR-Ram 333 modules????

I suffer big problems when using them together. If i use them both alone the system works fine. together instability and blue screens. Is it a matter of adjusting or something else. Need help please !!

Greetings Frank_IX

[Frank_IX]

btw

i use a MSI KT3 Ultra ARU MB (Raid is "off")
1 Seagate Barracuda ATA IV ST360021A HD at IDE 1 Master
1 Seagate Barracuda ATA II (old - for backup-reasons only) at IDE 1 Slave
1 Pioneer DVD on IDE 2 Master
1 HP Burner on IDE 2 Slave
1 10/100 Realtech-compatible network-card
1 Adaptec Firewire-card
1 GEforce 4 MX

something else .....?

Greetings Frank_IX

[Rick83]

did you check your speed settings in your bios? i heard nanya-ram are not the fastest... but samsung should be very fast and pretty shure you can set it to cl2, nanya-modules will not run as fast...

[Frank_IX]

I set to "SPD".

so setting should be made automatically. This can't be wrong IMHO.

Greetings Frank_IX

[Rick83]

yes, but give it a try and set it to 3, if it works try it with 2... and you should also try the other options... there are really a lot of settings... ;-(

[Frank_IX]

Thx until now.

New information:

My local vendor says that there may be some problems between MSI-Boards and some DDR Memory. Samsung seems to have this failure.

Greetings Frank_IX