Put Layer O and Layer 1 in seperate DLTs- for Replication

[Deepa DvD]

Hello everyone!
Well, I was talking to a replicator and he says that I need to provide Layer O on a seperate DLT & Layer 1 on a seperate DLT.How do I do that? I still have the project saved in Scenarist.And have the premaster on a 20GB DLT(that Scenarist built), with both of the layers.
Thanks In Advance!:)

[celmar]

With Scenarist you must specify Before if you want a single layer or two layers project.
During premastering on DLT, Scenarist will claim inserting second DLT
for layer 1. The first DLT is Layer 0.

With Maestro, if the project is too big for a single layer, just
specify 2 layers and choose the layer point break and chek Opposite track.

[Deepa DvD]

Thanks for the reply bro!
I appreciate it very much!
I have Scenarist and Yes, I did Specify dual layer & layer break.When I was writing the project to DLT I think I did get a message like (please replace...) and I just pressed OK. Was that the message to replace the tape and insert a new one for the 2nd layer? and I also noticed when I got that message, the DLT drive stopped writing to the DLT & when I pressed OK, it started writing again.
Thanks!
Deepa

[Arky]

Funny thing is, I was going to suggest you check out this post, which may be relevant in getting *towards* your goal:

http://forum.doom9.org/showthread.php?s=&threadid=29756&highlight=arky+opposite

...But then I realised it was a thread which you started anyway!

Well, I hope you succeed.


Arky ;o)

[Deepa DvD]

Oh yes, I remember that Arky!
Thanks!:)