Maestro & Chapters

[bizo]

I have followed Trilights DVD-9 to DVD-5 "Full Copy" Instructions and had great results until now!!
Ripped ALI every thing has gone fine until i load the chapter list. Then Maestro says Loaded 19 Chapters when there should be 32. they are also all over the place, no relation to what Chapterxtrator says.
NE1 seen this or have a solution.:angry:

[Arky]

Did you remember to convert the chapter points (if necessary), to fit the appropriate video frame rate?


Arky ;o)

[bizo]

Where do i do that?

Thanks for replying!!

[mikeathome]

Hi,

it's basically not the Video Frame Rate it's the offset of the VideoStream.
You have to add the offset in ChapterXtractor while exporting. Get the offset from the VideoStream Properties (in Maestro right click the stream) calculate the ms (milliseconds) and add them in ChapterXtractor. Then he'll import all of the chapters.

mike

[Mazze]

Copied my post from an other thread:

It was like 3 months ago I experienced this so the info might not be 100% sure.

It has something to do with the wallclock.
When importing the video the wallclock changes to about 01:00:00:00.
After resetting the wallclock to zero the audio lines up perfectly when importing, however the subtitles still imports a hour late, meaning the subtitles starts in the middle of the movie or something like that.

My solution was to manually edit the chapters list in notepad and add 1h to each time entry. Hope it works out for you.

[auenf]

Originally posted by Mazze
Copied my post from an other thread:

It was like 3 months ago I experienced this so the info might not be 100% sure.

It has something to do with the wallclock.
When importing the video the wallclock changes to about 01:00:00:00.
After resetting the wallclock to zero the audio lines up perfectly when importing, however the subtitles still imports a hour late, meaning the subtitles starts in the middle of the movie or something like that.

My solution was to manually edit the chapters list in notepad and add 1h to each time entry. Hope it works out for you.

the default timecode start in CCE is the problem you're describing

Enf...

[denfert]

add the 01:00:00:00 delay in ms in chaptorXtractor

for exemple here is 01:00:00:00 (1 hour) so
60x60x1000=3600000 ms

or download our nice calculator
http://www.dvdguru.net/download_files.php?id=442