hjl113
20th February 2002, 12:25
I recently did a rip and I usually do it with highest quality(1800-2000kbps)
When I did a compressibility check under gknot@5%, the bits/pixel I set was around .4. After the check the box was red and the percentage was something like 130%, which mean good quality. However, The Final divx size was a lot smaller than I calculated for.
Is raiging the bit rate the only solution so make it a larger file?
I know I did an overkill with the bit rate but I want to stay that high.
Here is the keyframe question. I did a DRF Analyzer and found out that there was too little key frames in the movie. (I saved all frames with Level 2, so DRF was 2)
I usually go for 3 CDs, what are the best setting for 2hr movie onto 3CDs(2100MB)?
I would greatly appreciate your help.
When I did a compressibility check under gknot@5%, the bits/pixel I set was around .4. After the check the box was red and the percentage was something like 130%, which mean good quality. However, The Final divx size was a lot smaller than I calculated for.
Is raiging the bit rate the only solution so make it a larger file?
I know I did an overkill with the bit rate but I want to stay that high.
Here is the keyframe question. I did a DRF Analyzer and found out that there was too little key frames in the movie. (I saved all frames with Level 2, so DRF was 2)
I usually go for 3 CDs, what are the best setting for 2hr movie onto 3CDs(2100MB)?
I would greatly appreciate your help.