movmasty
19th February 2002, 08:38
http://forum.doom9.org/showthread.php?s=&threadid=17247
yes, i noticed that too.
say that u want to use a lower drf at the begin,to give a better introduction to a clip,say u set first 1000 frames at drf x(0-999)
then,if u have another FIXED drf for your movie(x+1), nandub will use the drf setted in ecf for the first 1000 frames in all the movie
that doenst happen if u did the first pass and drf r not fixed but based on bitrate or motion.
im used to solve that writing a second line in the ecf,setting the right drf for the rest of the movie,
then i dont need settings in drf tab.
another thing, to set the right drf for the rest of the movie,i have to write: range as "1000-end number",
does the ecf sintax permit to write "1000-" or "1000-0"
without have to look at the end of the movie??
yes, i noticed that too.
say that u want to use a lower drf at the begin,to give a better introduction to a clip,say u set first 1000 frames at drf x(0-999)
then,if u have another FIXED drf for your movie(x+1), nandub will use the drf setted in ecf for the first 1000 frames in all the movie
that doenst happen if u did the first pass and drf r not fixed but based on bitrate or motion.
im used to solve that writing a second line in the ecf,setting the right drf for the rest of the movie,
then i dont need settings in drf tab.
another thing, to set the right drf for the rest of the movie,i have to write: range as "1000-end number",
does the ecf sintax permit to write "1000-" or "1000-0"
without have to look at the end of the movie??