Problem with gknot's encoder tab (job control)

[Bricolo]

I use divx3 with nandub
i've done everything right, decrypting, 1st pass, ecf and stats creating
but when i add the 2nd pass to gknot's job list, and i start encoding, nandub use default values (like spacekf=12, and all other options)

the problem is that the job control doesn't load gknot.vcf

[Bricolo]

26 views, 0 replyes...


can s/o tell me if it is normal?? or is it a bug?

[diji1]

Hi,

I think it is something u are doing wrong - normally nandub loads .vcf files when i use the job control.....

[UHT]

sounds like you havent followed the guide to the letter as i have never experienced this.....read through the guide again, and once more then try it agai

*nice to see u around diji :)*

[diji1]

Howdy UHT ( not UTH ... lol ),

Good to see u also mate! Been a bit busy lately to get on the net very much ( but im still encoding my a*** off ) :D Website is looking more impressive everyday, btw, thanks for providing ur time.

Take care.