Check integrity of .m2ts blu-ray streams?

[futureman]

Hi,

I was wondering if there is some way I can check the integrity of .m2ts streams from ripped Blu-Ray's.
I ripped some of my blu-ray movies in the very beginning of it all, and I did notice some video glitches and audio skips on a couple of my complete disk rips. I was wondering is I can run a program to test is the stream on the rip is ok and glitch free, so i don't have to bo back and rip eveything again.

Thanks in advance.

[allanon019]

Sorry can't think of any program, but what you can do is this: take the original Blu-ray check the bottom of it to see if it's in good condition.
Next, play it in a Blu-ray player and fast forward through the whole movie to see if it plays without any glitching (also look for the parts of the movie where you saw the discrepencies happen).
If you don't think that's the problem could you tell us the movie and the version of AnyDVD you were using, perhaps it wasn't decrypt properly.

[Anacletus]

Hi,

I was wondering if there is some way I can check the integrity of .m2ts streams from ripped Blu-Ray's.
I ripped some of my blu-ray movies in the very beginning of it all, and I did notice some video glitches and audio skips on a couple of my complete disk rips. I was wondering is I can run a program to test is the stream on the rip is ok and glitch free, so i don't have to bo back and rip eveything again.

Thanks in advance.

Guess you can use eac3to xxxxxx.m2ts -check

regards
Anac