TS file trimmer

[armadillo22]

Hi all

I have a number of h264 TS files that have some branding at the begining (company logo etc)...thing is...they've decided to now change ALL their branding.

So I'm looking for a tool that will allow me to trim and join TS files.

I've used h264TSCutter in the past and of course this was the tool I first went to. However these files I have to trim are over 1h 30mins and after approximately 30 seconds after opening the file and attempting to make a cut the program freezes and refuse to respond.

I've checked out a number of other tools that claim to trim/join the type of files I have such as Xilisofts 'Video Editor', Boilsofts 'Splitter' and 'Joiner'...but no luck.

Anyone know of any other tools (either freeware or commercial) that might perform the task?

Many Thanks

-A

[shpitz]

Did you try VideoRedo? I use it to trim .ts files and it works great. I also use Mpeg2Cut so try that as well. I don't have any specific experience with joining .ts files as I always record to a single file.

[armadillo22]

They're both MPEG2 only.

I need a solution for Mpeg4.

[rica]

I've been cutting them with TSMuxer for some time.
But if you want a professional tool, try Elecard XMuxerPro.( for detailed cut you will need Elecard AVC Plug-in as well.)

[mikeathome]

Hi,
I use TSremux for my DVB HD (h.264) captures with success:

- use e.g. MPC to figure out trim points
- use TSRemux to apply the trim
* if you specify just a few secs to be remuxed that can be fairly fast and you get perfect cut points, write them down and apply them on the whole stream
** start with Trim Beginning: click the Trim End Hour up until the full length is shown
** input the desired Trim Beginning (from MPC check), reduce Trim End by ~10secs
** that way you end up muxing only 10secs trimmed at the beginning - FAST! - search for best cut point by adjusting
** do the same for Trim End: click the Trim Beginning Hour up until full length is shown
** input the desired Trim End (from MPC check), reduce Trim Beginning by ~10secs
** that way you end up muxing only 10secs trimmed at the end - FAST! - search for best cut point by adjusting
** enter the found cut points in Trim Beginning and Trim End and remux

Works very well, for me. All freeware!

mike