IfoEdit Aspect Ratio Correction

[129ten]

There was beautiful article on how to correct aspect ratio or how to make 4:3 to 16:9 using ifoedit. Found that long time ago on different site(Digital Forum). I did put that to my favorites list.... now however it displays that site is on longer avaiable?. Anybody know what happend to them?, and I'm looking for that guide on how to set 16:9 flag to correct aspect ratio using ifoedit.You guys know where I can find it?
Regards,129ten

[blutach]

There's an easier way.

Load your DVD project into PgcEdit. Navigate to the domain of the title concerned. Ctrl-a. Change the AR (note in 16:9, either or both of auto LB or auto P&S must be ticked). OK and save and you're done.

By the way, if it is Digital Digest that you are speaking of, many of their threads, guides and other stuff were withdrawn after their decrypting and DVD Shrink forums were forced to close. Nonetheless, it is an editing guide, which should remain. I'll see if I can find it and bring it back.

Regards

[setarip_old]

@129ten

Hi!

I believe the following link is the article you've seen before:

http://www.dvdr-digest.com/articles/42_1.html

[129ten]

Thx to both of guys. Will try to use pgcedit way like "blutach" discribes.

Setarip_old ... the link you posted is the guide I had in mind and used that in the past. Right now that link is dead. Explorer can not display website... this is message Im getting after I've tried.
Regards

[setarip_old]

That link was active/valid when I originally posted it - and it is active/valid as of this very moment...