qwik3r2
31st December 2006, 19:00
This has been my first time using CCE to encode an xvid to DVD. The reason i am using CCE is because my 1 click solution that i normally use (vso's convertx2dvd) makes the audio on this one particular xvid out of synch, go figure.
Anyway I can't get the damned aspect ratio correct it just doesn't look right no matter what i do in CCE. The input AR is 672x272 2.46:1 my settings are mpeg2 for dvd doing 1 pass just to see the AR is right or not and i have tried 4:3 with resize to 720x480 and 16:9 and it still comes out odd. Odd meaning the people look ok the AR is "correct" however there is a square box AROUND the entire video it doesn't extend to the sides etc. If it did it correctly i would expect the black lines on top and bottom but there is a gap left to right also, sorry if i am a bit confusing but any advice would be good. Thanks.
Anyway I can't get the damned aspect ratio correct it just doesn't look right no matter what i do in CCE. The input AR is 672x272 2.46:1 my settings are mpeg2 for dvd doing 1 pass just to see the AR is right or not and i have tried 4:3 with resize to 720x480 and 16:9 and it still comes out odd. Odd meaning the people look ok the AR is "correct" however there is a square box AROUND the entire video it doesn't extend to the sides etc. If it did it correctly i would expect the black lines on top and bottom but there is a gap left to right also, sorry if i am a bit confusing but any advice would be good. Thanks.