Could not open log file for reading....

[Maehdrescher]

Hi out there,
hope some folks can help me. I'm using claddvd 2.0 to backup the vob files from my dvds to my harddisk. When finished I make an avi file with flaskmpeg. There were never problems before. I ripped about 4-5 movies now.
I do same at the moment with the movie "What woman want". Ripping the vob files to my harddisk works, but when clicking "Flask this disk" to start creating the avi file, i get the following: "Fatal error: Could not open log file for reading".
I tried these progs as well, but nothing changed: Smartripper, Cladmdec, DVDx1.6, EasyDivx and DVDRipper.
Somebody knows this mistake? :confused:
Thx, Ben

[Znarf]

Hi,

I think your are using multipass.

After you choose the codec (divx 4.11 I supose), you have to configure it.

You probably select "Two pass, pass two". Change that to "One pass", or "Two pass, pass one".

If you select "Two pass, pass one", you have to specify the log file (on bottom right) to creat it.
At the end of this pass, you have to to the same thing with selecting "Two pass, pass two". Then you have to select the log file you created before.

I hope you will understand me (I'm french with bad English !!). If not, ask me again.