DVD-RB 1.09.2 and HC 0.18 not working

[rpboy]

I just downloaded the new HC encoder release and put the HCenc_018.exe file in the folder with the other HC encoder EXE. In DVD-RB, I changed the path to the encoder to point to the new EXE, but it still launched 0.17. So I deleted the 0.17 HC EXE file and tried again. This time, DVD-RB says it can't find the encoder.

Do we need a new version of DVD-RB to support a new HC encoder release?

[dialysis1]

Did you rename it to HCbatch.exe?

[rahzel]

you shouldnt have to. i just changed the directory to the new version in the setup and it worked.

[rpboy]

Did you rename it to HCbatch.exe?
I tried that, but it didn't work. I also downloaded the ZIP file again and extracted the EXE file again in case there was a problem the first time.

[rpboy]

you shouldnt have to. i just changed the directory to the new version in the setup and it worked.
Hmm, I just dropped the new EXE in the folder created under the DVD-RB folder where the others were.

I wonder if putting it in a different folder would make a difference. Its actually busy doing something right now, so I'll have to try that later.

[jdobbs]

If you just drop it in the folder, you will have to rename it. If you go into SETUP and point to it, it really doesn't make a difference what name you use.

By default DVD-RB looks for HCBatch.exe.

It's working fine on my system.

[rpboy]

If you just drop it in the folder, you will have to rename it. If you go into SETUP and point to it, it really doesn't make a difference what name you use.

By default DVD-RB looks for HCBatch.exe.

It's working fine on my system.
Tried that and it didn't work. I went into setup and pointed it at the new file and I still got that error message.

I downloaded 1.09.3 though and copied the EXE files out of the ZIP, the two DVD-RB files and the HC encoder file, dropped them in place and now everything is working fine.