Extras bigger than Movie

[oddie]

Ok, this is probably answered before, but i couldnt find the right answer

The extras of my dvd are bigger than the movie, so for dvd-rb the movie are the extras (because is the bigger) , so what i need is to change the "priority" and steal space from the extras, because now, dvd-rb is stealing space from the movie.

thanks

[jdobbs]

The only thing you can do is set it to 0%. What DVD is it? Finding a VTS that is larger than the entire film is exceptionally rare except in those that have two versions (fullscreen and widescreen).

[oddie]

thanks for the answer :D


is the third disk of season 3 of family guy

the extras are 3.1gb and the movie 2.8gb

problem is that im going to loose quality without stealing space to the extras because the total size of the disk is 7.84gb

perhaps it could be a nice feature in the future ;)

[MrShow]

problem is that im going to loose quality without stealing space to the extras because the total size of the disk is 7.84gb
Don't know what encoder your using but with CCE I didn't notice any quality problems with this disc. I didn't remove anything(unless there were trailers)and the quality is just fine.

[pg55555]

Suggestion:

Use Shrink, select "No Compresion" for the movie, and "Custom" for the extras.
Set the compression ratio for the extras so they are smaller than the movie (a 85 / 88% should do it).
Shrink output will have now the movie VTS bigger than the extras, so you can run your standard RB backup procedure on it.

[oddie]

Suggestion:

Use Shrink, select "No Compresion" for the movie, and "Custom" for the extras.
Set the compression ratio for the extras so they are smaller than the movie (a 85 / 88% should do it).
Shrink output will have now the movie VTS bigger than the extras, so you can run your standard RB backup procedure on it.

good idea, im gonna try that

thanks

[wmansir]

Also keep in mind there are addon tools linked in the Overview sticky thread which allow you to adjust the bitrate of each VTS or segment.

Ecl Optimizer is very easy to use, just run the prepare phase in DVD-RB, open ECL Optimizer and select the Rebuild.ECL file from the working directory. Make your changes, apply and save the results and then start the encode phase in DVD-RB.