About the "Two Click" feature.

[Rockas]

I had the information that if someone aborts the "Encode phase" and then hit "encode" again... Rebuilder won't jump into the "Rebuild Phase" and shutdown the computer automatically even if that option was checked previously... can anyone confirm this? (sorry... I can't check that myself at this moment).

thanks

[Rippraff]

If you are working in "Two click" mode you have to hit rebuild instead of encode. RB checks if the encode phase is already done, otherwise it'll start the encode phase first.

Cu Rippraff

[jdobbs]

That's correct. The shutdown occurs after a REBUILD. So selecting just to ENCODE would never reach it. As Rippraff said, If you want to finish the encode phase followed by a REBUILD, (and then shutdown if selected) you'd have to push the REBUILD button rather than ENCODE when you continue.

The option is called "Shutdown at REBUILD completion" after all. ;)